ESAB® 15Z17 OXWELD 1502 1-Piece Hand/Machine Cutting Tip, 1/2 in Tip, Acetylene Gas

• Hard drawn, electrolytic, tough pitch copper used in one-piece nozzles - withstands heat and wear - outlasts any copper alloy nozzle
• One-piece nozzle has triple swaged interior - gas passages are mirror smooth with internal angles rounded for non-turbulent, more efficient gas flow - clean, smooth cuts with minimal kerf
• Preheat ports are closely spaced around cutting orifice for greater concentration of preheat flames
• Long, parallel preheat passages - permit re-dressing nozzle without affecting performance
• One-piece nozzle is a single piece of solid copper - provides maximum cooling - recommended always for acetylene and for other fuel gases when heat exposure is unusually severe
• Two-piece nozzles - recommended for high efficiency with fuel gases other than acetylene - solid copper, heavy-wall external sleeve and brass internal sections can be ordered separately to minimize replacement cost
• Conical seats - instant aligning provides tight seal, prevents leaks around nozzle nut

General Purpose, Cutting Dirty Plate, Beveling, Industrial and General Fabrication, Structural Steel Fabrication, Light Fabrication, Repair and Maintenance Applications