3M™ 7000119741 Disposable Lid, For Use With 3M™ Paint Preparation System, 200 micron Filter, 5.5 oz Mini Cup

3M™ PPS™ mini and micro lids only contains 25 lids, filters and 10 sealing plugs for use with the 3M™ paint preparation system (PPS™ ). This all-in-one painting system allows painters to mix/measure, filter, spray (in any direction!) and temporarily protect coating materials. PPS™ disposable lids contain a welded-in filter which strains the paint material while spraying. 3M™ PPS™ mini and micro lids only contains 25 disposable lids with pre-welded micron filters for straining paint for use with the 3M™ paint preparation system (PPS™ ). The case will either contain 125 micron filters which are often recommended for water-borne paint materials or 200 micron filters for traditional solvent-based paint materials. Always reference the paint manufacturer to ensure the recommended filter to strain the paint material. The mini PPS™ allows technicians to mix graduated measurements of up to 6 fluid oz (180 mL) when used with a mix ratio film insert or by weight scale. The micro PPS™ allows technicians to mix graduated measurements of up to 3 fluid oz (90 mL) mini PPS™ is ideal for 1-panel repairs and micro PPS™ is ideal for spot repair. Use PPS™ mini and micro lids with 3M™ mini/micro size cup and collar part number 16115. Mini size PPS™ refers to paint volume mixes of up to 6 fl-oz (180 mL), ideal for a 1-panel repairs. Micro size PPS™ refers to paint volume mixes of up to 3 fl-oz (90 mL), ideal for spot repairs. Unlike conventional paint cup systems, our 3M™ PPS™ eliminates the need for mixing paint in additional paint mix cups and then transferring the paint through a separate filter into a paint reservoir. This is an important advantage because waste occurs every time that a user transfers paint through mixing cups and filters. With pps™ , you place the disposable liner within the re-usable PPS™ cup. Then simply mix the paint in the PPS™ disposable liner, snap the disposable lid (with the pre-welded filter) in place and attach the locking collar to complete the PPS™ system. With just these few simple steps, you're ready to start spraying. PPS™ allows the painter to spray consistently 90 deg to the part, no matter how the part is positioned. This makes material transfer more consistent, limits paint overspray and lowers paint consumption. Because PPS™ is a closed system, you can operate in any orientation - i.e. 360 degrees. After spraying, the painter can use a sealing plug to seal and protect paint materials or simply discard disposable lid and liner, leaving only the adapter and spray gun to clean. Discard the disposable lid and liner in the appropriate approved waste containers specified by the paint manufacturer (or local government requirements). Use a small amount of solvent for cleaning the spray gun and the PPS™ adapter. With this disposable paint system, shops are often experiencing a 70% reduction in cleaning solvents, which means solvent cleaning savings and solvent disposal savings. Most guns can be cleaned with less than 3 oz. Of solvent. Specifically designed PPS™ stainless steel metal adapters allow painters to use the PPS™ system with virtually any spray gun. Painters have also the option to use the 3M™ Accuspray™ ONE spray gun, which requires no adapters. Technicians have found that this spray gun further reduces cleaning solvent usage and cleaning and maintenance time. Because the painter uses a new disposable lid (with welded-in filter) and disposable liner for each mix, there is less risk of outside contamination due to mixing, filtering and clean up. Using a fresh lid and liner with each paint job, rather than washing out reusable components, often improves overall productivity in prep and cleanup time by as much as 50%.