Koyo CRSB-14 Inch Series Stud Type Uncaged Needle Bearing Track Roller, 7/8 in Dia x 1/2 in W Roller, 3/8 in Dia x 0.88 in L Stud

CRSB14 MFG #: CRSB-14
$23.75 / EA
Koyo CRSB-14 Inch Series Stud Type Uncaged Needle Bearing Track Roller, 7/8 in Dia x 1/2 in W Roller, 3/8 in Dia x 0.88 in L Stud
Koyo Needle Bearing Track Roller, Stud Type Uncaged, Series: CRSB Inch Series, 7/8 in Roller Diameter, 1/2 in Roller Width, 3/8 in Stud Diameter, 0.88 in Stud Length, 3/8-24 Thread, 3/8 in Thread Length, 1660 lbf Dynamic/2670 lbf Static Load, 3800 rpm Grease Maximum, -25 to 225 deg F, Sealed Closure, Hex Wrench Socket Head, Black Oxide
QTY
Add to List
  • Non-separable, sealed unit with outer ring, full complement of needle rollers, stud seals, self-lubr
  • Seals help retain lubricant and exclude foreign matter
  • Hexagonal wrench socket in stud head for mounting
  • Re-lubrication via axially drilled hole through stud with cross-drilled holes in stud raceway and sh
  • Recessed axial hole accepts standard nominal inch drive-type grease lubrication fitting
  • Lubrication fitting plugs furnished to close off unused holes
  • Tolerance limits for outer diameters of stud and outer ring refer to "single mean diameter"
  • A close fit between stud and hole required for mounting
  • Retaining washer should be firmly backed up by flat housing shoulder (perpendicular to the stud axis
  • Shoulder diameter should be atleast same size as minimum clamping diameter listed
  • May be mounted with two thin lock nuts or nut and lock washer
Non-separable, sealed unit with outer ring, full complement of needle rollers, stud seals, self-lubricating resin internal thrust washers and stud-fastened retaining washer
Seals help retain lubricant and exclude foreign matter
Hexagonal wrench socket in stud head for mounting
Re-lubrication via axially drilled hole through stud with cross-drilled holes in stud raceway and shank
Recessed axial hole accepts standard nominal inch drive-type grease lubrication fitting
Lubrication fitting plugs furnished to close off unused holes
Tolerance limits for outer diameters of stud and outer ring refer to "single mean diameter"
A close fit between stud and hole required for mounting
Retaining washer should be firmly backed up by flat housing shoulder (perpendicular to the stud axis)
Shoulder diameter should be atleast same size as minimum clamping diameter listed
May be mounted with two thin lock nuts or nut and lock washer