Dixon® BU9 Boss™ 2-Bolt Clamp, 3/4 in ID x 1-10/64 to 1-20/64 in OD, Iron Band
BU9
MFG #: BU9
$15.06
/ EA
Estimated Delivery in 3 to 4 Business Days
- Manufacturer: Dixon Valve & Coupling
- Series: Boss™
- Inside Diameter: 3/4
- Outside Diameter: 1-10/64 to 1-20/64
- Length: 2-31/32
- Width: 2-9/16
- Bolt Size: 9/16 in Hex
- Torque Rating: 21
- Band Material: Iron
- Finish: Zinc Plated
- Brand: Dixon®
Dixon® 2-Bolt Clamp, Series: Boss™, 3/4 in Inside Dia, 1-10/64 to 1-20/64 in Outside Dia, 2-31/32 in Length, 2-9/16 in Width, 9/16 in Hex Bolt, 21 ft lb, Iron Band, Zinc Plated
- Recommended for steam service up to 450 deg F
- Replacement nuts and bolts are available
- Two gripping fingers and two clamps sections
- The bolts used in the boss interlocking clamps are not standard bolts
- They vary from standard bolts in their lengths, diameter, overall thread lengths and materials hardn
- These bolts can be retorqued, but it is not recommended to reuse the bolts or clamps, as they are de
- Torque values for clamps are based on dry bolts
- The use of lubricant on bolts will adversely effect clamps performance
- Do not lubricate nuts and bolts
- Bolts in boss clamps are designed to bend as they are tightened and this allows the clamps to confor
- Always tighten bolts to their specified torque values
- Periodic re-tightening of bolts is required due to "cold flow" phenomenon present in all rubber hose
- Boss clamps are for single use only, once removed they are to be discarded
- Warning: this products contains a chemicals known to the State of California to caused birth defects
- Do not use in connections with drinking water
- Wash hands after handling
- Global investment cast carbon steel
Recommended for steam service up to 450 deg F
Replacement nuts and bolts are available
Two gripping fingers and two clamps sections
The bolts used in the boss interlocking clamps are not standard bolts
They vary from standard bolts in their lengths, diameter, overall thread lengths and materials hardness
These bolts can be retorqued, but it is not recommended to reuse the bolts or clamps, as they are designed for a single bend only
Torque values for clamps are based on dry bolts
The use of lubricant on bolts will adversely effect clamps performance
Do not lubricate nuts and bolts
Bolts in boss clamps are designed to bend as they are tightened and this allows the clamps to conform to the hose outside diameter
Always tighten bolts to their specified torque values
Periodic re-tightening of bolts is required due to "cold flow" phenomenon present in all rubber hoses
Boss clamps are for single use only, once removed they are to be discarded
Warning: this products contains a chemicals known to the State of California to caused birth defects or other reproductive harm
Do not use in connections with drinking water
Wash hands after handling
Global investment cast carbon steel