2in Submersable Trash Pump
SV400-115
MFG #: 290784
$1,327.95
/ EA
Estimated Delivery 7 to 10 Business Days
JET Submersible Trash Pump, 59 gpm, 2 in MNPT Outlet, 22 ft Maximum Head, 1/2 hp, 115 VAC, 7.6 A, 60 Hz Frequency, 1 ph, 3450 rpm Motor, STOW 16/3 AWG 33 ft Cord, 1.1 Service Factor, Vortex Impeller, 104 deg F, 304 Stainless Steel Casing and Rotor Shaft/Buna-N Lip Seal and O-Ring/Cast Iron Volute
- Equipped with vortex impellers, undoubtedly the best non-clog impellers ever invented for the handli
- Longer power cord standard 33 ft power cord
- 304 stainless steel motor housing superior abrasion resistance will not wear out like aluminum motor
- Three seal motor protection - motor is protected by double mechanical seals
- Lower seal made of silicon carbide and upper seal is made of carbon/ceramic
- An additional lip seal has been installed above the impeller, to help prevent abrasives such as dirt
- More motor protection - winding protection and NEMA class F motor insulation allows motor temperatur
- Automatic switch turns pump motor off if temperature and/or amp draw raises too high
- When the motor cools the switch will automatically reset and the pump will turn back on
- Tough pump construction - hardened cast iron stands up to rough handling and pumping sandy water unl
- They pass solid upto 90% of pump outlet diameter
Equipped with vortex impellers, undoubtedly the best non-clog impellers ever invented for the handling of mud, raw sewage, viscous liquids, rags, wood chips and other solids
Longer power cord standard 33 ft power cord
304 stainless steel motor housing superior abrasion resistance will not wear out like aluminum motor housings when pumping sandy water
Three seal motor protection - motor is protected by double mechanical seals
Lower seal made of silicon carbide and upper seal is made of carbon/ceramic
An additional lip seal has been installed above the impeller, to help prevent abrasives such as dirt, silt or sand, from entering into the seal chamber
More motor protection - winding protection and NEMA class F motor insulation allows motor temperature to raise to 230 deg F, superior to pumps with class A and B insulation
Automatic switch turns pump motor off if temperature and/or amp draw raises too high
When the motor cools the switch will automatically reset and the pump will turn back on
Tough pump construction - hardened cast iron stands up to rough handling and pumping sandy water unlike pumps with soft resin impellers or plastic exterior components
They pass solid upto 90% of pump outlet diameter