REHAU® PRO-BALANCE® 260166 4-Wire Valve Actuator

634642 MFG #: 260166
$81.50 / EA
Estimated Delivery in 3 to 4 Business Days
REHAU® PRO-BALANCE® 260166 4-Wire Valve Actuator
  • Manufacturer: REHAU
  • Type: 4-Wire
  • Power Supply: 24
  • Temperature Rating: 32 to 140
  • Suitable For Use With: PRO-BALANCE® Manifold
  • Brand: REHAU®
REHAU® PRO-BALANCE® Valve Actuator, 4-Wire, 24 VAC Supply, 32 to 140 deg F, For Use With: PRO-BALANCE® Manifold
QTY
Add to List
  • Gray position indicator provides visual verification of the actuator's position
  • When the actuator is on and open, the gray indicator will rise out of the top of the actuator and be
  • Red pull-out tab is provided to allow easy installation onto the manifold, after installation remove
  • A dry-contact end switch is built-In to the actuator
  • This end switch can be used to operate 24 VAC (2 amps max.) relays for pumps and other devices and c
  • If required, connect the green end switch wires to a suitable 24 VAC-powered relay to activate a dev
  • 24 VAC "thermal motor" heating element melts a wax cartridge, allowing the actuator to open when the
  • 4 wires: blue/brown - apply 24 vac power, green (2) - end switch, length - 40 in (100 cm)
  • Low power draw: approximately 2 VA in operation, maximum 4.5 VA when first powered, ensures transfor
Gray position indicator provides visual verification of the actuator's position
When the actuator is on and open, the gray indicator will rise out of the top of the actuator and be visible from the side
Red pull-out tab is provided to allow easy installation onto the manifold, after installation remove red tab
A dry-contact end switch is built-In to the actuator
This end switch can be used to operate 24 VAC (2 amps max.) relays for pumps and other devices and can be wired so that pumps turn on only when actuator is fully open
If required, connect the green end switch wires to a suitable 24 VAC-powered relay to activate a device to be operated by the actuator's end switch or connect these wires directly into an appropriate zone control module
24 VAC "thermal motor" heating element melts a wax cartridge, allowing the actuator to open when there is a call for heat (power on), when the power is off, the wax cools and closes the valve (normally closed), operation takes 3-4 minutes
4 wires: blue/brown - apply 24 vac power, green (2) - end switch, length - 40 in (100 cm)
Low power draw: approximately 2 VA in operation, maximum 4.5 VA when first powered, ensures transformer has sufficient power (VA) to operate all actuators