JET 290771 Heavy Duty Submersible Pump, 50 gpm Flow Rate, 2 in MNPT Outlet, 1, 1/2 hp, 304 Stainless Steel Casing and Rotor Shaft/Buna-N Lip Seal and O-Ring/Cast Iron Volute

290771 MFG #: 290771
Requires Quote
JET 290771 Heavy Duty Submersible Pump, 50 gpm Flow Rate, 2 in MNPT Outlet, 1, 1/2 hp, 304 Stainless Steel Casing and Rotor Shaft/Buna-N Lip Seal and O-Ring/Cast Iron Volute
  • Request For Quote: Yes
JET Submersible Pump, Heavy Duty, 50 gpm, 2 in MNPT Outlet, 36 ft Maximum Head, 1/2 hp, 115 VAC, 0.25 A, 60 Hz, 1, 3450 rpm Motor, STOW 16/3 AWG 33 ft Cord, Service Factor: 1.1, Multi-Vane Impeller, 104 deg F, 304 Stainless Steel Casing and Rotor Shaft/Buna-N Lip Seal and O-Ring/Cast Iron Volute
QTY
Add to List
  • Top discharge allows for superior cooling of motor and provides a slim line design
  • 304 stainless steel motor housing superior abrasion resistance will not wear out like aluminum motor
  • Three seal motor protection - Motor is protected by double mechanical seals
  • Lower seal made of silicon carbide and upper seal is made of carbon/ceramic
  • An additional lip seal has been installed above the impeller, to help prevent abrasives such as dirt
  • More motor protection - winding protection and NEMA class F motor insulation allows motor temperatur
  • Automatic switch turns pump motor off if temperature and/or amp draw raises too high
  • When the motor cools the switch will automatically reset and the pump will turn back on
  • Tough pump construction - Hardened cast iron stands up to rough handling and pumping sandy water unl
  • Longer power cord - standard 33 ft power cord
Top discharge allows for superior cooling of motor and provides a slim line design
304 stainless steel motor housing superior abrasion resistance will not wear out like aluminum motor housings when pumping sandy water
Three seal motor protection - Motor is protected by double mechanical seals
Lower seal made of silicon carbide and upper seal is made of carbon/ceramic
An additional lip seal has been installed above the impeller, to help prevent abrasives such as dirt, silt or sand, from entering into the seal chamber
More motor protection - winding protection and NEMA class F motor insulation allows motor temperature to raise to 230 deg F, superior to pumps with class A and B insulation
Automatic switch turns pump motor off if temperature and/or amp draw raises too high
When the motor cools the switch will automatically reset and the pump will turn back on
Tough pump construction - Hardened cast iron stands up to rough handling and pumping sandy water unlike pumps with soft resin impellers or plastic exterior components
Longer power cord - standard 33 ft power cord